User Manual
Table Of Contents
- Mellanox WinOF VPI User Manual
- Table of Contents
- List of Tables
- Document Revision History
- About this Manual
- 1 Introduction
- 2 Driver Features
- 3 Deploying Windows Server 2012 with SMB Direct
- 4 Driver Configuration
- 5 Performance Tuning
- 6 OpenSM - Subnet Manager
- 7 InfiniBand Fabric
- 7.1 Network Direct Interface
- 7.2 part_man - Virtual IPoIB Port Creation Utility
- 7.3 InfiniBand Fabric Diagnostic Utilities
- 7.4 InfiniBand Fabric Performance Utilities
- 7.4.1 ib_read_bw
- 7.4.2 ib_read_lat
- 7.4.3 ib_send_bw
- 7.4.4 ib_send_lat
- 7.4.5 ib_write_bw
- 7.4.6 ib_write_lat
- 7.4.7 ibv_read_bw
- 7.4.8 ibv_read_lat
- 7.4.9 ibv_send_bw
- 7.4.10 ibv_send_lat
- 7.4.11 ibv_write_bw
- 7.4.12 ibv_write_lat
- 7.4.13 ibaddr
- 7.4.14 ibcacheedit
- 7.4.15 iblinkinfo
- 7.4.16 ibqueryerrors
- 7.4.17 ibsysstat
- 7.4.18 perfquery
- 7.4.19 saquery
- 7.4.20 smpdump
- 8 Software Development Kit
- 9 Troubleshooting
- 10 Documentation
Driver ConfigurationRev 4.3
Mellanox Technologies
35
Step 2. Right-click a Mellanox network adapter (under “Network adapters” list) and left-click Proper-
ties. Select the Advanced tab from the Properties sheet.
Step 3. Modify configuration parameters to suit your system.
Please note the following:
a. For help on a specific parameter/option, check the help window at the bottom of the
dialog.
b. If you select one of the entries Offload Options, Performance Options, or Flow Control
Options, you’ll need to click the Properties button to modify parameters via a pop-up
dialog. See example in the two figures below.
c. A “Use Default for All” button appears on the Advanced dialog. Click this button to set
all entries (and their sub-entries) to the Mellanox Ethernet driver default values. You
will be prompted to approve this action.