User Manual
Table Of Contents
- Mellanox WinOF VPI User Manual
- Table of Contents
- List of Tables
- Document Revision History
- About this Manual
- 1 Introduction
- 2 Driver Features
- 3 Deploying Windows Server 2012 with SMB Direct
- 4 Driver Configuration
- 5 Performance Tuning
- 6 OpenSM - Subnet Manager
- 7 InfiniBand Fabric
- 7.1 Network Direct Interface
- 7.2 part_man - Virtual IPoIB Port Creation Utility
- 7.3 InfiniBand Fabric Diagnostic Utilities
- 7.4 InfiniBand Fabric Performance Utilities
- 7.4.1 ib_read_bw
- 7.4.2 ib_read_lat
- 7.4.3 ib_send_bw
- 7.4.4 ib_send_lat
- 7.4.5 ib_write_bw
- 7.4.6 ib_write_lat
- 7.4.7 ibv_read_bw
- 7.4.8 ibv_read_lat
- 7.4.9 ibv_send_bw
- 7.4.10 ibv_send_lat
- 7.4.11 ibv_write_bw
- 7.4.12 ibv_write_lat
- 7.4.13 ibaddr
- 7.4.14 ibcacheedit
- 7.4.15 iblinkinfo
- 7.4.16 ibqueryerrors
- 7.4.17 ibsysstat
- 7.4.18 perfquery
- 7.4.19 saquery
- 7.4.20 smpdump
- 8 Software Development Kit
- 9 Troubleshooting
- 10 Documentation
InfiniBand FabricRev 4.3
Mellanox Technologies
97
7.4.16.2 ibqueryerrors Options
Table 33 - ibqueryerrors Flags and Options
Flags Description
-s <err1,err2,...> Suppresses the errors listed in the comma separated list pro-
vided.
-c Suppresses some of the common "side effect" counters.
These counters usually do not indicate an error condition and
can be usually be safely ignored.
-G <port_guid> -S <port_guid> --port-
guid
Report results for the port specified. For switches results are
printed for all ports not just switch port 0.
-S same as "-G" Provided only for backward compatibility
-D <direct_route> Reports results for the port specified. For switches results are
printed for all ports not just switch port 0.
-r Reports the port information. This includes LID, port, exter-
nal port (if applicable), link speed setting, remote GUID,
remote port, remote external port (if applicable), and remote
node description information.
--data Includes the optional transmit and receive data counters.
--threshold-file Specifies an alternate threshold file.
The default is:
/opt/ufm/files/conf/infiniband-diags/error_thresholds
--switch Prints data for switches only.
--ca Prints data for CA’s only.
--router Prints data for routers only
--clear-errors-k Clear error counters after read. -k and -K can be used
together to clear both errors and counters.
--clear-counts -K Clear data counters after read.
CAUTION: clearing data counters will occur regardless of if
they
are printed or not. This is because data counters are
only
printed on ports which have errors. This means if a port
has 0
errors and the -K option is specified the data counters will
be
cleared without any printed output.
-details Includes receive error and transmits discard details