User Manual
Table Of Contents
- 1. Knowing BIOS
- 2. BIOS setup program
- 3. My Favorites
- 4. Main menu
- 5. Ai Tweaker menu
- 6. Advanced menu
- 6.1 Trusted Computing
- 6.2 AMD fTPM configuration
- 6.3 AMD CBS
- 6.4 CPU Configuration
- 6.5 PCI Subsystem Settings
- 6.6 USB Configuration
- 6.7 Network Stack Configuration
- 6.8 NVMe Configuration
- 6.9 HDD/SSD SMART Information
- 6.10 SATA Configuration
- 6.11 APM Configuration
- 6.12 Onboard Devices Configuration
- 6.13 NB Configuration
- 6.14 AMD PBS
- 6.15 AMD Overclocking
- 7. Monitor menu
- 8. Boot menu
- 9. Tool menu
- 10. Exit menu
- 11. Updating BIOS
PRIME / ProArt / TUF GAMING AMD 600 Series BIOS Manual
37
SNP Memory (RMP Table) Coverage
When this item is set to [Enabled], the ENTIE system memory is covered.
Configuration options: [Disabled] [Enabled] [Custom] [Auto]
The following item appears only when SNP Memory (RMP Table) Coverage is set to
[Custom].
Amount of Memory to Cover
Specify MB of System Memory to be covered in Hex.
Configuration options: [0] - [100000]
SMEE
Control secure memory enryption enable.
Configuration options: [Disable] [Enable] [Auto]
Action on BIST Failure
Allows you to set the action to take when a CCD BIST failure is detected.
Configuration options: [Do nothing] [Down-CCD] [Auto]
DF Common Options
Memory Addressing
Memory interleaving
Allows for disabling memory channel interleaving.
Configuration options: [Disabled] [Auto]
Memory interleaving size
Controls the memory interleaving size. The valid values are AUTO, 256 bytes, 512 bytes,
1 Kbytes, or 2 Kbytes. This determines the starting address of the interleave (bit 8, 9, 10
or 11).
Configuration options: [256 Bytes] [512 Bytes] [1KB] [2KB]
DRAM map inversion
Inverting the map will cause the highest memory channels to get assigned the lowest
addresses in the system.
Configuration options: [Disable] [Enable] [Auto]
Location of private memory regions
Controls whether or not the private memory regions (PSP, SMU and CC6) are at the top
of DRAM pair or distributed. Note that distributed requires memory on all dies. Note that
it will always be at the top of DRAM if some dies don’t have memory regardless of this
option’s setting.
Configuration options: [Distributed] [Consolidated] [Consolidated to 1st DRAM pair] [Auto]
ACPI
ACPI SRAT L3 Cache as NUMA Domain
[Disabled] Memory Addressing \ NUMA nodes per socket will be declared.
[Enabled] Each CCX in the system will be declared as a separate NUMA
domain.
[Auto] Sets to the default option.
Disable DF to external downstream IP Sync Flood Propagation
Disables Error propagation to UMC or any downstream slaves eg. FCH. Use this to
avoid reset in failure scenario.
Configuration options: [Sync flood disabled] [Sync flood enabled] [Auto]