User’s Manual

ASUS PRIME H410M-E
1-3
• M.2slot(KeyM),type2242/2260/2280(supportsPCIe3.0x2&SATAmodes).
• M.2slotsupportsdatatransferspeedsupto16Gb/s.
• WhenadeviceinSATAmodeisinstalledontheM.2slot,SATA6G_2portcannotbe
used.
7. SATA 6Gb/s ports
TheSATA6Gb/sportsallowyoutoconnectSATAdevicessuchasopticaldiscdrivesand
harddiskdrivesviaaSATAcable.
8. USB 3.2 Gen 1 header
TheUSB3.2Gen1headerallowsyoutoconnectaUSB3.2Gen
1moduleforadditionalUSB3.2Gen1ports.TheUSB3.2Gen1
headerprovidesdatatransferspeedsofupto5Gb/s.
TheUSB3.2Gen1moduleispurchasedseparately.
9. USB 2.0 headers
TheUSB2.0headersallowyoutoconnectaUSBmoduleforadditionalUSB
2.0ports.TheUSB2.0headersprovidedatatransferspeedsofupto480Mb/s
connection speed.
DONOTconnecta1394cabletotheUSBconnectors.Doingsowill
damage the motherboard!
TheUSB2.0moduleispurchasedseparately.
10. Clear CMOS header
ThisheaderallowsyoutocleartheCMOSRTCRAMdataofthesystemsetup
informationsuchasdate,time,andsystempasswords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
 2. Useametalobjectsuchasascrewdrivertoshortthetwopins.
 3. PlugthepowercordandturnONthecomputer.
4. Hold down the <Del>keyduringthebootprocessandenterBIOSsetuptore-
enter data.
Ifthestepsabovedonothelp,removetheonboardbatteryandshortthetwopinsagainto
cleartheCMOSRTCRAMdata.AfterclearingtheCMOS,reinstallthebattery.
11. COM Port header
This header is for a serial (COM) port. Connect the serial port module cable
tothisheader,theninstallthemoduletoaslotopeningatthebackofthe
system chassis.
PIN 1
USB+5V USB_P1- USB_P1+ GND NC
USB+5V
USB_P2-
USB_P12+
GND
CLRTC
+3V_BAT GND
PIN 1
USB3+5V
IntA_P1_SSRX-
IntA_P1_SSRX+
GND
IntA_P1_SSTX-
IntA_P1_SSTX+
GND
IntA_P1_D-
IntA_P1_D+
GND
PIN 1
USB3+5V
IntA_P2_SSRX-
IntA_P2_SSRX+
GND
IntA_P2_SSTX-
IntA_P2_SSTX+
GND
IntA_P2_D-
IntA_P2_D+
PIN 1
DCD
TXD
GND
RTS
RI
RXD
DTR
DSR
CTS