User Manual

4-22
第四章：BIOS 程式設定
Read Timing Centering 2D
設定值有：[Enabled] [Disabled]
Command Voltage Centering
設定值有：[Enabled] [Disabled]
Write Voltage Centering 2D
設定值有：[Enabled] [Disabled]
Read Voltage Centering 2D
設定值有：[Auto] [Enabled] [Disabled]
Late Command Training
設定值有：[Auto] [Enabled] [Disabled]
Round Trip Latency
設定值有：[Auto] [Enabled] [Disabled]
Turn Around Timing Training
設定值有：[Enabled] [Disabled]
Rank Margin Tool
設定值有：[Auto] [Enabled] [Disabled]
Margin Check Limit
本項目可以檢視開機記憶體是否需要重設。
設定值有：[Disabled] [L1] [L2] [Both]
Margin Limit Check L2
L2 check threshold is scale of L1 check.
設定值有：[1] - [300]
Memory Test
設定值有：[Enabled] [Disabled]
DIMM SPD Alias Test
設定值有：[Enabled] [Disabled]
Receive Enable Centering 1D
設定值有：[Enabled] [Disabled]
Retrain Margin Check
設定值有：[Enabled] [Disabled]
CMD Drive Strength and Tx Equalization
設定值有：[Auto] [Enabled] [Disabled]
CMD Slew Rate Training
設定值有：[Auto] [Enabled] [Disabled]
Write Drive Strength Up/Dn independently
設定值有：[Enabled] [Disabled]
以下項目只有當 Margin Check Limit 設定為 [L2] 或 [Both] 時才會出現。