User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-81ASUS Control Center Express
Share Drive
Allows you to share a USB storage device.
1. Check
Share Drive
, and ensure the remote device’s USB function is
enabled.
2. Select the USB storage device you wish to mount.
3. If the USB storage device is successfully mounted,
Ready for
communication
will be displayed in the
Message
column.
5.8.6 Smart BIOS
This item allows you to update the BIOS of a device by uploading a BIOS file
manually or from the BIOS Cache if the device cannot be powered on to perform a
BIOS update or repair.
The client device will begin updating the BIOS after shutting down. The update
process may take a while, please wait for the update to be finished. Once the
BIOS flash is finished the client device will restart.
DO NOT disconnect the power supply during the BIOS flash.
Flashing BIOS by manually uploading BIOS file
Manually upload a BIOS file to flash the BIOS of the client device. The BIOS file
uploaded and flashed with will be added to the BIOS Cache.
1. Select
Manually Upload BIOS File
in the
BIOS
Flash
Type
field.
2. Click on
Browse
to select a BIOS file, then click
OK
to confirm the BIOS file
was uploaded successfully. The uploaded BIOS file will also be added to the
BIOS Cache