User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing Agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading older versions of agents or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.14 BSOD Capture
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
8-12 Chapter 8: Account & General Settings
Account
Set the default account to log into the client device’s vPro remote
management controller.
Password
Set the default password to log into the client device’s vPro
remote management controller.
vPro Account:
Set the default login account used to log into the client vPro remote management
controller. Click on
Save
to save the changes made.
Account
Set the default administrator account.
Password
Set the default administrator password.
Agent device’s administrator account:
Set the default administrator account and password for client devices if no
administrator account and password were entered when deploying agents. Click
on
Save
to save the changes made.
• If the account type is a domain account, you may enter the account in
the format
Domain\Account
, which will set the default account used when
deploying to a domain account.
• When using the default account when deploying, make sure of the
language of the client device. The system account with administrator
privileges may differ according to the system language, and may affect
agent deployment to that device.
The account and password entered should match the account and password
for the client device’s vPro remote management controller.