User’s Manual
Table Of Contents
- About this guide
- Chapter 1: Getting Started
- Chapter 2: Main Menu Overview
- Chapter 3: Deploy Management
- 3.1 Agent Management overview
- 3.2 Deploying agents
- 3.2.1 Automatically scanning and deploying to devices
- 3.2.2 Scanning an IP range
- 3.2.3 Adding and deploying to devices
- 3.2.4 Editing device information
- 3.2.5 Installing agents manually
- 3.2.6 Installing Agents in silent mode
- 3.2.7 Upgrading or repairing agents
- 3.2.8 Setting up a Windows 7 deployment environment
- 3.3 Removing agents
- 3.4 Client Agent Updater
- Chapter 4: Device Information
- Chapter 5: Management Functions
- 5.1 Metadata Management
- 5.2 Software Management
- 5.3 Task Scheduler
- 5.4 OOB Control
- 5.5 Management Control Overview
- 5.6 Management Control Information Overview
- 5.7 DASH Management Control Information
- 5.8 RTL8117 Management Control Information
- 5.9 vPro Management Control Information
- 5.10 BMC Management Control Information
- 5.10.1 Hardware Sensor
- 5.10.2 Inventory
- 5.10.3 Control
- 5.10.4 Remote Desktop
- 5.10.5 Smart BIOS
- 5.10.6 Firmware Update
- 5.10.7 Event Log
- 5.10.8 IPMI
- 5.10.9 IPMI Serial-over-LAN (SOL)
- 5.10.10 Settings
- 5.10.11 Configuration
- 5.10.12 FRU Information
- 5.10.13 Image Redirection
- 5.10.14 Platform Event Filters
- 5.10.15 BSOD Capture
- 5.10.16 Error Codes
- 5.11 Screen Broadcast
- Chapter 6: Settings Migrator
- Chapter 7: Report Generator
- Chapter 8: Account & General Settings
5-174 Chapter 5: Management Functions
5.11.4 Starting or stopping a broadcast
You can start or stop the broadcast of an existing broadcast room by following the
below steps:
1. Navigate to the
Broadcast Room
of an existing broadcast room.
2. Scroll to the bottom of the page, then click on
Play
.
3. You can view the data transmission rate and health status of the broadcast
in the
Broadcast Source
block.
4. You can configure or view the settings of the broadcast from the items
located at the bottom of the Broadcast Preview.
Play / Stop
Play or stop the broadcast.
Volume
Adjust the volume of the preview broadcast of the main
server.
This option only affects the volume of the
broadcast source, and will not adjust the
volume for client devices.
Video Status
Displays the current status of the broadcast.
Settings
Allows you to toggle the
Video status
on/off, and also
select the quality of the broadcast.
Picture-in-Picture
Select if you would like to view the preview broadcast in
Picture-in-Picture (PiP).
Full Screen
Select if you would like to view the preview broadcast in
full screen.