User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- 2.1 Building your PC system
- 2.1.1 CPU installation
- 2.1.2 Cooling system installation
- 2.1.3 DIMM installation
- 2.1.4 M.2 installation
- 2.1.5 Motherboard installation
- 2.1.6 ATX power connection
- 2.1.7 SATA device connection
- 2.1.8 Front I/O connector
- 2.1.9 Expansion card installation
- 2.1.10 USB 3.2 Gen 2 Type-C® monitor connection
- 2.1.11 M.2 Wi-Fi module and antenna installation
- 2.2 BIOS update utility
- 2.3 Motherboard rear and audio connections
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- 2.1 Building your PC system
- Chapter 3: BIOS and RAID Support
- Appendix
2-10
Chapter 2: Basic Installation
Chapter 2
• To install an M.2 to M.2_2 slot
For 2280, 22110 length
A. (optional) Remove the pre-installed removable M.2 Q-Latch screw at the
2280 length screw hole.
Follow step A only when you wish to install an 22110 length M.2 to M.2_3.
B. (optional) Install the bundled rubber for M.2 if you are installing a single
sided M.2 storage device. DO NOT install the bundled rubber for M.2 when
installing a double-sided M.2 storage device. The rubber installed by default
is compatible with double sided M.2 storage devices.
C. Rotate and adjust the M.2 Q-latch so that the handle points away from the
M.2 slot.
D. Install your M.2 to the M.2 slot.
E. Rotate the M.2 Q-Latch clockwise to secure the M.2 in place.
OPTIONAL
Bundled rubber for M.2