User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- 2.1 Building your PC system
- 2.1.1 CPU installation
- 2.1.2 Cooling system installation
- 2.1.3 DIMM installation
- 2.1.4 M.2 installation
- 2.1.5 Motherboard installation
- 2.1.6 ATX power connection
- 2.1.7 SATA device connection
- 2.1.8 Front I/O connector
- 2.1.9 Expansion card installation
- 2.1.10 USB 3.2 Gen 2 Type-C® monitor connection
- 2.1.11 M.2 Wi-Fi module and antenna installation
- 2.2 BIOS update utility
- 2.3 Motherboard rear and audio connections
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- 2.1 Building your PC system
- Chapter 3: BIOS and RAID Support
- Appendix
ProArt B650-CREATOR
2-11
Chapter 2
For 2242, 2260 length
A. (optional) Remove the M.2 rubber.
Follow this step only if you wish to install an M.2 to type 2242.
B. (optional) If required, remove the pre-installed removable M.2 Q-Latch screw
at the 2280 length screw hole.
C. Install the M.2 Q-Latch to the M.2 length screw hole you wish to install your
M.2 to.
D. Rotate and adjust the M.2 Q-latch so that the handle points away from the
M.2 slot.
E. Install your M.2 to the M.2 slot.
F. Rotate the M.2 Q-Latch clockwise to secure the M.2 in place.