User Manual

ManualsBrandsAsus ManualsEye CareProArt Display OLED PA32DC

◼ If you want to update the firmware on your ProArt Display using a USB drive,

please check if your USB drive is MBR (Master Boot Record).

Check USB Disk Partition Format

1. Type "Disk Management" into the search bar.

2. Click "Create and format hard disk partitions".

Summary of content (8 pages)

PAGE 1
◼ If you want to update the firmware on your ProArt Display using a USB drive, please check if your USB drive is MBR (Master Boot Record). Check USB Disk Partition Format 1. Type "Disk Management" into the search bar. 2. Click "Create and format hard disk partitions".
PAGE 2
3. Right-click on the USB disk number (on the left side). From the context menu, choose "Properties". Click "Volumes" tab and check the "Partition style". 4. The partition style should use MBR format.
PAGE 3
Convert a GPT disk into an MBR disk by Windows PowerShell (before converting the format, please remember to backup important data on the USB drive because formatting will erase the data.) 1. Type “powershell" into the search bar. 2. Click “Run as Administrator”. 3. Type the following command to list USB disks and use the disks and use the disk number for subsequent commands Get-Disk | Where-Object -FilterScript {$_.Bustype -Eq "USB"} 4.
PAGE 4
◼ If you use PA32DC, it must use FAT32 format. Create a FAT32 partition that is smaller than 32GB in size (Only for PA32DC) Before creating a FAT32 partition, please first delete the USB disk partitions: 1. 2. Right-click on the USB volume (on the right side) you want to delete. From the context menu, choose "Delete Volume".
PAGE 5
3. From the warning prompt, click "Yes". After deletion, we can create a FAT32 partition. Due to a Windows limitation, a FAT32 partition can only be created if it is smaller than 32GB: 1. 2. Right-click on the USB (the right side). From the context menu, choose "New Simple Volume".
PAGE 6
3. From the wizard, click "Next" to continue.
PAGE 7
4. Enter "2048" MB for the volume size. 5. Click "Next" to use the default drive letter. 6. Choose "FAT32" for the File system.
PAGE 8
7. Click the "Finish" button.