User Manual
PA34V Firmware Update Procedures
When there is a newer version of rmware available on the ASUS website, follow the
procedures below to update your monitor. Make sure that the power supply is stable
and the USB drive is plugged in during the whole process.
1. Download and extract the rmware le “PA34V_Test_0313.7z” to the root directory of a
USB 2.0 drive. (File system: FAT32.) The monitor can only be upgraded using rmware le
named “PA34V.bin”.
2. Remove the USB cover and insert the USB drive into the USB 2.0 A-type port at the back
of the monitor.
3. Press both buttons above the power button simultaneously. The monitor will begin the
rmware update which takes about 2 minutes. If you have a power failure during rmware
update, the monitor will stop the process and turn off. After power resumes, the monitor will
continue the rmware update and reboot within 5 minutes. Contact your local service center
if you encounter any problems.
Updating firmware.
Do not turn off power until the
finishing message appears.
Firmware update completed.
Please switch AC power on/off
once before using monitor.
4. After the firmware update completes, switch off the monitor using the power switch on the
back.
5. Turn on the monitor and reset all settings via the System Setup menu. The OSD menu
settings will be restored to factory defaults.
System Setup
Bac k
Lan gua g e
Cal ibr a ti on R emi n de r
Dis pla y Po rt S tre a m
Key Lo c k
Pow er I nd icat or
Inf orm a ti on
All Re s et
AS US PA3 4V
St and ard M ode T hun de rbo lt 34 40 x 144 0@ 100 Hz
6. Download and extract the rmware le “EDID_0222.7z” to the root directory of a USB 2.0
drive. (File system: FAT32.) The monitor can only be upgraded using rmware le named
“PA34V.bin”. Repeat the above step 2 ~ 5 to update the rmware.
7. Download and extract the rmware le “PA34V_0228.7z” to the root directory of a USB 2.0
drive. (File system: FAT32.) The monitor can only be upgraded using rmware le named
“PA34V.bin”. Repeat the above step 2 ~ 5 to update the rmware.