User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Start ASUS EzFlash
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 Platform Misc Configuration
- 3.3.5 CPU Configuration
- 3.3.6 System Agent (SA) Configuration
- 3.3.7 PCH Storage Configuration
- 3.3.8 Onboard Devices Configuration
- 3.3.9 ACPI Settings
- 3.3.10 LVDS Configuration
- 3.3.11 APM Configuration
- 3.3.12 NCT6116D Super IO Configuration
- 3.3.13 NCT6116D HW Monitor
- 3.3.14 Serial Port Console Redirection
- 3.3.15 Intel TXT Information
- 3.3.16 USB Configuration
- 3.3.17 NVMe Configuration
- 3.3.18 HDD Secure Erase
- 3.3.19 Dynamic Digital IO
- 3.3.20 Network Stack Configuration
- 3.4 Security menu
- 3.5 Boot menu
- 3.6 Save & Exit menu
- 3.7 Event Logs
- BIOS setup
- Appendix
2-13
Chapter 2: Motherboard information
8. Chassis intrusion header (4-1 pin_CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The
chassis intrusion sensor or switch sends a low-level signal to this connector
when a chassis component is installed. The signal is then generated as a chassis
intrusion event.
Q370I-IM-A R2.0 Chassis Intruder connector
PIN 1
3
4
3
4
CHASSIS
PIN 1
Chassis Intruder - Close Chassis Intruder - Open
3-4jumper closed
3-4jumper removed (Default)
Connector type
HEADER 4p, K2, 2.54mm pitch