User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Start ASUS EzFlash
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 Platform Misc Configuration
- 3.3.5 CPU Configuration
- 3.3.6 System Agent (SA) Configuration
- 3.3.7 PCH Storage Configuration
- 3.3.8 Onboard Devices Configuration
- 3.3.9 ACPI Settings
- 3.3.10 LVDS Configuration
- 3.3.11 APM Configuration
- 3.3.12 NCT6116D Super IO Configuration
- 3.3.13 NCT6116D HW Monitor
- 3.3.14 Serial Port Console Redirection
- 3.3.15 Intel TXT Information
- 3.3.16 USB Configuration
- 3.3.17 NVMe Configuration
- 3.3.18 HDD Secure Erase
- 3.3.19 Dynamic Digital IO
- 3.3.20 Network Stack Configuration
- 3.4 Security menu
- 3.5 Boot menu
- 3.6 Save & Exit menu
- 3.7 Event Logs
- BIOS setup
- Appendix
3-10
Q370I-IM-A R3.0
EDID Data Source
Conguration options: [Pre-Dened] [Flat Panel Display]
The following item appears when you set EDID Data Source to [Pre-Dened].
Pre-DenedLVDSPanelType
Allows you to select Pre-Dened LVDS panel used by Internal Graphics
Device. Conguration options: [VBIOS Default] [640x480] [800x600]
[1024x768] [1280x1024] [1400x1050 (RB) LVDS1] [1400x1050 LVDS2]
[1600x1200 LVDS] [1366x768 LVDS] [1680x1050] [1920x1200]
[1024x768 LVDS2] [1280x800] [1920x1080 LVDS] [2048x1536 LVDS]
[1366x768 LVDS]
Inverter Polarity
Conguration options: [Normal] [Inverted]
Channel Select
Conguration options: [Dual Channel] [Single Channel]
Mode Select
Confuguration options: [JEIDA] [VESA 6bit] [VESA 8bit] [VESA 10bit]
DIGON enable to LVDS_ON enable(T2)
Conguration options: [0] ~[50]
LVDS_ON enable to BLON enable (T3)
Conguration options: [0] ~[1023]
BLON disable to LVDS_ON disable (T4)
Conguration options: [0] ~[1023]
LVDS_ON disable to DIGON disbale (T5)
Conguration options: [0] ~[50]
Completion of power down to power up (T7)
Conguration options: [0] ~[1023]
VARY_BL enable to BL_EN enable (T9)
Conguration options: [0] ~[1023]
BL_EN disable to VARY_BL disable (T10)
Conguration options: [0] ~[1023]
3.3.11 APMConguration
Restore AC Power Loss
[S0] The system goes into on state after an AC power loss.
[S5] The system goes into off state after an AC power loss.