User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 Start ASUS EzFlash
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 Platform Misc Configuration
- 3.3.5 CPU Configuration
- 3.3.6 System Agent (SA) Configuration
- 3.3.7 PCH Storage Configuration
- 3.3.8 Onboard Devices Configuration
- 3.3.9 ACPI Settings
- 3.3.10 LVDS Configuration
- 3.3.11 APM Configuration
- 3.3.12 NCT6116D Super IO Configuration
- 3.3.13 NCT6116D HW Monitor
- 3.3.14 Serial Port Console Redirection
- 3.3.15 Intel TXT Information
- 3.3.16 USB Configuration
- 3.3.17 NVMe Configuration
- 3.3.18 HDD Secure Erase
- 3.3.19 Dynamic Digital IO
- 3.3.20 Network Stack Configuration
- 3.4 Security menu
- 3.5 Boot menu
- 3.6 Save & Exit menu
- 3.7 Event Logs
- BIOS setup
- Appendix
3-18
Q370I-IM-A R3.0
3.4 Security menu
This menu allows a new password to be created or a current password to be changed. The
menu also enables or disables the Secure Boot state and lets the user congure the System
Mode state.
Administrator Password
If you have set an administrator password, we recommend that you enter the
administrator password for accessing the system.
To set an administrator password:
1. Select the Administrator Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Conrm the password when prompted.
To change an administrator password:
1. Select the Administrator Password item and press <Enter>.
2. From the Enter Current Password box, key in the current password, then press
<Enter>.
3. From the Create New Password box, key in a new password, then press <Enter>.
4. Conrm the password when prompted.
To clear the administrator password, follow the same steps as in changing an
administrator password, but press <Enter> when prompted to create/conrm the
password.
User Password
If you have set a user password, you must enter the user password for accessing
the system. The User Password item on top of the screen shows the default Not
Installed. After you set a password, this item shows Installed.
To set a user password:
1. Select the User Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Conrm the password when prompted.
To change a user password:
1. Select the User Password item and press <Enter>.
2. From the Enter Current Password box, key in the current password, then press
<Enter>.
3. From the Create New Password box, key in a new password, then press <Enter>.
4. Conrm the password when prompted.
To clear a user password:
1. Select the Clear User Password item and press <Enter>.
2. Select Yes from the Warning message window then press <Enter>.