User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Ai Tweaker menu
- 3.3.1 CPU Power Enhancement
- 3.3.2 CPU Core Ratio
- 3.3.3 DRAM Odd Ratio Mode
- 3.3.4 DRAM Frequency
- 3.3.5 Power-saving & Performance Mode
- 3.3.6 DRAM Timing Control
- 3.3.7 DIGI+ VRM
- 3.3.8 Internal CPU Power Management
- 3.3.9 CPU Core/Cache Current Limit Max.
- 3.3.10 CPU Graphics Current Limit
- 3.3.11 Min. CPU Cache Ratio
- 3.3.12 Max. CPU Cache Ratio
- 3.3.13 Max. CPU Graphics Ratio
- 3.3.14 DRAM Voltage
- 3.3.15 DRAM REF Voltage Control
- 3.4 Advanced menu
- 3.4.1 Platform Misc Configuration
- 3.4.2 CPU Configuration
- 3.4.3 System Agent (SA) Configuration
- 3.4.4 PCH Configuration
- 3.4.5 PCH Storage Configuration
- 3.4.6 PCH-FW Configuration
- 3.4.7 AMT Configuration
- 3.4.8 Trusted Computing
- 3.4.9 Onboard Devices Configuration
- 3.4.10 APM Configuration
- 3.4.11 Serial Port Console Redirection
- 3.4.12 Intel TXT Information
- 3.4.13 PCI Subsystem Settings
- 3.4.14 USB Configuration
- 3.4.15 Network Stack Configuration
- 3.4.16 NVMe Configuration
- 3.4.17 HDD Secure Erase
- 3.4.18 HDD/SSD SMART Information
- 3.5 Monitor menu
- 3.6 Boot menu
- 3.7 Tool menu
- 3.8 Exit menu
- BIOS setup
- Appendix
3-29
Chapter 3: BIOS setup
XHCI Hand-off
This item is set to [Disabled] by default for the EHCI (enhanced host controller
interface) support by XHCI drivers in operating systems.
[Disabled] Support XHCI by XHCI drivers for operating systems with XHCI
support.
[Enabled] Support XHCI by BIOS for operating systems without XHCI
support.
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to the manual for the location of the USB ports.
3.4.15 Network Stack Configuration
Network Stack
This item allows user to disable or enable the UEFI network stack. Conguration
options: [Disabled] [Enabled]
The following two items appear only when you set the previous item to
[Enabled].
Ipv4 PXE Support
This item allows user to disable or enable the Ipv4 PXE Boot support.
Conguration options: [Disabled] [Enabled]
Ipv6 PXE Support
This item allows user to disable or enable the Ipv6 PXE Boot support.
Conguration options: [Disabled] [Enabled]
3.4.16 NVMe Configuration
This menu displays the NVMe controller and drive information of the connected
devices.
3.4.17 HDD Secure Erase
This menu displays the HDDs that suppot Secure Erase function.
3.4.18 HDD/SSD SMART Information
This menu displays the SMART information of the connected devices.