User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 Power Management
- 3.3.7 PCI Express Configuration
- 3.3.8 AMT Configuration
- 3.3.9 Super IO Configuration
- 3.3.10 Serial Console Redirection
- 3.3.11 SATA Configuration
- 3.3.12 VMD setup menu
- 3.3.13 Network Stack Configuration
- 3.3.14 USB Configuration
- 3.3.15 NVMe Configuration
- 3.3.16 Onboard Devices Configuration
- 3.3.17 Miscellaneous
- 3.3.18 APM Configuration
- 3.3.19 EZ-Flash
- 3.3.20 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
2-17
Chapter 2: Motherboard information
CAUTION! Never connect a 1394 cable to the USB connector. Doing so will
damage the motherboard.
NOTE: The USB cable is purchased separately.
3. USB 2.0 header (10-1 pin USB213)
This header is for an USB 2.0 port. Connect the USB cable to this header.
This USB header complies with USB 2.0 specification that supports up to 480
Mbps connection speed.
USB_213
Q670EI-IM-A
USB+5V
USB_P1-
USB_P1+
GND
NC
USB+5V
USB_P2-
USB_P2+
GND
PIN 1
4. General purpose input/output connector (10-pin GPIO_CON)
This connector is for a general purpose input/output module which allows you
to customize the digital signal input/output.
GPIO1
GPIO3
GPIO5
GPIO7
+3V
GPIO2
GPIO4
GPIO6
GPIO8
GND
PIN 1
Q670EI-IM-A
GPIO_CON
Connector type
Header 2x5p, K9, 2.0mm pitch
Connector type
WAFER HD 2x5p, 2.0mm pitch, S/T