User Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 Power Management
- 3.3.7 PCI Express Configuration
- 3.3.8 AMT Configuration
- 3.3.9 Super IO Configuration
- 3.3.10 Serial Console Redirection
- 3.3.11 SATA Configuration
- 3.3.12 VMD setup menu
- 3.3.13 Network Stack Configuration
- 3.3.14 USB Configuration
- 3.3.15 NVMe Configuration
- 3.3.16 Onboard Devices Configuration
- 3.3.17 Miscellaneous
- 3.3.18 APM Configuration
- 3.3.19 EZ-Flash
- 3.3.20 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS setup
- Appendix
3-10
Q670EI-IM-A
[Mark] Parity bit is always 1.
[Space] Parity bit is always 0.
Mark and Space Parity do not allow for error detection.
Stop Bits
Stop bits indicate the end of a serial data packet. The standard setting is 1
stop bit. Communication with slow devices may require more than 1 stop bit.
Configuration options: [1] [2]
Flow Control
Flow control can prevent data loss from buffer overflow. When sending
data, if the receiving buffers are full, a “stop” signal can be sent to stop the
data flow. Once the buffers are empty, a “start” signal can be sent to re-start
the flow. Hardware flow control uses two wires to send start/stop signals.
Configuration options: [None] [Hardware RTS/CTS]
VT-UTF8 Combo Key Support
Allows you to enable or disable VT-UTF8 Combination Key Support for ANSI/
VT100 terminals. Configuration options: [Disabled] [Enabled]
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal
data. Configuration options: [Disabled] [Enabled]
Resolution 100x31
Allows you to enable or disable extended terminal resolution.
Configuration options: [Disabled] [Enabled]
Putty KeyPad
Allows you to select FunctionKey and KeyPad on Putty.
Configuration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400]
COM6(Pci Bus0,Dev0,Func0) (Disabled)
The following items can be configured only when AMT is provisioned.
Console Redirection Settings
Redirection COM Port
Allows you to select a COM port to display redirection of Legacy OS and
Legacy OPROM Messages.
Configuration options: [COM1] [COM2] [COM3] [COM4] [COM5] [COM6(Pci
Bus0,Dev0,Func0) (Disabled)]
Resolution
This allows you to set the number of rows and columns supported on the
Legacy OS. Configuration options: [80x24] [80x25]