User Manual
Table Of Contents
- Chapter 1 Product Overview
- Chapter 2: Motherboard Information
- Chapter 3: BIOS Setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 Power Management
- 3.3.6 PCI Express Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 VMD setup menu
- 3.3.11 Network Stack Configuration
- 3.3.12 USB Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 Onboard Devices Configuration
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 IO Expander Configuration
- 3.3.18 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
Q670EM-IM-A
2-12
4. Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
Connector type
HEADER 4p, K2, 2.54mm pitch
+5VSB_MB
Chassis Signal
GND
CHASSIS
PIN 1