User Manual
Table Of Contents
- Chapter 1 Product Overview
- Chapter 2: Motherboard Information
- Chapter 3: BIOS Setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 Power Management
- 3.3.6 PCI Express Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 VMD setup menu
- 3.3.11 Network Stack Configuration
- 3.3.12 USB Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 Onboard Devices Configuration
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 IO Expander Configuration
- 3.3.18 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
2-19
Chapter 2: Motherboard information
Do not forget to connect the fan cables to the fan headers. Insufficient air flow
inside the system may damage the motherboard components. These are not
jumpers! Do not place jumper caps on the fan headers!
7. CPU and Chassis Fan headers (4-pin CPU_FAN, 4-pin CHA_FAN1-3)
Connect the fan cables to the fan headers on the motherboard, ensuring that
the black wire of each cable matches the ground pin of the header.
Connector type
WAFER HD 4p, 2.54mm pitch, S/T
CHA_FAN1
CHA_FAN3
CHA_FAN2
CPU_FAN
CHA FAN PWM
CHA FAN IN
CHA FAN PWR
GND
CPU FAN PWM
CPU FAN IN
CPU FAN PWR
GND
A
B
C
D
A
B
C
D
8. SATA 6.0Gb/s ports (7-pin SATA6G_1-7)
These ports connect to Serial ATA 6.0 Gb/s hard disk drives or an optical
drive via Serial ATA 6.0 Gb/s signal cables.
Connector type
WAFER HD 7p, 1.27mm pitch
SATA6G_67
A
B
SATA6G_45
C
SATA6G_23
D
SATA6G_1
A
B
C
D