User Manual
Table Of Contents
- Chapter 1 Product Overview
- Chapter 2: Motherboard Information
- Chapter 3: BIOS Setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 PCH-FW Configuration
- 3.3.2 Trusted Computing
- 3.3.3 CPU Configuration
- 3.3.4 Graphics Configuration
- 3.3.5 Power Management
- 3.3.6 PCI Express Configuration
- 3.3.7 Super IO Configuration
- 3.3.8 Serial Console Redirection
- 3.3.9 SATA Configuration
- 3.3.10 VMD setup menu
- 3.3.11 Network Stack Configuration
- 3.3.12 USB Configuration
- 3.3.13 NVMe Configuration
- 3.3.14 Onboard Devices Configuration
- 3.3.15 APM Configuration
- 3.3.16 EZ-Flash
- 3.3.17 IO Expander Configuration
- 3.3.18 Watchdog Timer
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- Appendix
2-23
Chapter 2: Motherboard information
14. Digital Audio header (4-1 pin SPDIF_OUT)
This header is for an additional Sony/Philips Digital Interface (S/PDIF) port.
Connect the S/PDIF Out module cable to this header, then install the module
to a slot opening at the back of the system chassis.
The SPDIF Out module is purchased separately.
Connector type
HEADER 1x4p, K2, 2.54mm pitch
SPDIF_OUT
+5V
SPDIFOUT
GND
PIN 1
15. I
2
C header (6-1 pin I2C)
The I
2
C (Inter-Integrated Circuit) header allows you to connect an I
2
C
compatible IoT security module.
Connector type
Header 2x3p, K6, 2.0mm pitch
PIN 1
PWR 3.3V
NC
I2C_CLK
I2C_DATA
GND
I2C