User Manual

3-12
Q670EM-IM-A
3.3.9 SATA Configuration
This item allows you to configure SATA device options settings.
SATA Controller(s)
Allows you to enables or disables the onboard SATA device.
Configuration options: [Disabled] [Enabled]
The following item appears only when you set SATA Controller(s) to [Enabled].
SATA Mode Selection
Allows you to determine how SATA controller(s) operate.
Configuration options: [AHCI]
SATA6G_1(~7)
Allows you to enable or disable SATA Port.
Configuration options: [Disabled] [Enabled]
M.2
Configuration options: [Disabled] [Enabled]
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data,
if the receiving buffers are full, a “stop” signal can be sent to stop the data
flow. Once the buffers are empty, a “start” signal can be sent to re-start the
flow. Hardware flow control uses two wires to send start/stop signals.
Configuration options: [None] [Hardware RTS/CTS]
VT-UTF8 Combo Key Support
Allows you to enable or disable VT-UTF8 Combination Key Support for ANSI/
VT100 terminals.
Configuration options: [Disabled] [Enabled]
Recorder Mode
With this mode enabled only text will be sent. This is to capture Terminal
data.
Configuration options: [Disabled] [Enabled]
Resolution 100x31
Allows you to enable or disable extended terminal resolution.
Configuration options: [Disabled] [Enabled]
Putty KeyPad
Allows you to select FunctionKey and KeyPad on Putty.
Configuration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400]