User Manual

3-14 Chapter 3: BIOS setup
READ to READ Delay(DR) 6 [Auto]
Configuration options: [Auto] [2 DRAM Clock] – [9 DRAM Clock]
READ to READ Delay(SR) 4 [Auto]
Configuration options: [Auto] [4 DRAM Clock] [6 DRAM Clock]
WRITE to WRITE Delay(DD) 7 [Auto]
Configuration options: [Auto] [2 DRAM Clock] – [9 DRAM Clock]
WRITE to WRITE Delay(DR) 7 [Auto]
Configuration options: [Auto] [2 DRAM Clock] – [9 DRAM Clock]
WRITE to WRITE Delay(SR) 4 [Auto]
Configuration options: [Auto] [4 DRAM Clock] [6 DRAM Clock]
3.3.14 EPU II Phase Control [Full Phase]EPU II Phase Control [Full Phase]
Allows you to select the EPU II Phase.
Configuration options: [Auto] [Normal] [Full Phase]
3.3.15 CPU Load-Line Calibration [Auto]Load-Line Calibration [Auto]
Allows you to select the CPU Load-Line mode.
Configuration options: [Auto] [Disabled] [Enabled]
3.3.16 CPU Differential Amplitude [Auto]
Different AMP might enhance BCLK overclocking ability.
Configuration options: [Auto] [700mV] [800mV] [900mV] [1000mV]
3.3.17 IOH Voltage OCP [Enabled]
Allows you to enable or disable the IOH over current protection.
3.3.18 DRAM Voltage OCP [Enabled]
Allows you to enable or disable the DRAM over current protection.
3.3.19 QPI Voltage OCP [Enabled]
Allows you to enable or disable the QPI over current protection.
3.3.20 Extreme OV [Disabled]
[Enabled] Enables the Extreme OV function.
[Disabled] Disables this function.