User Manual

3-18 Chapter 3: BIOS setup
3.4.4 SATA 1–6
While entering Setup, the BIOS automatically detects the presence of Serial ATA
devices. There is a separate sub-menu for each SATA device. Select a device item
then press <Enter> to display the SATA device information.
The BIOS automatically detects the values opposite the dimmed items (Device,
Vendor, Size, LBA Mode, Block Mode, PIO Mode, Async DMA, Ultra DMA, and
SMART monitoring). These values are not user-configurable. These items show
[Auto] if no IDE device is installed in the system.
Type [Auto]
Allows you to select the type of IDE drive installed.
[Not Installed] Select this option if no IDE drive is installed.
[Auto] Allows automatic selection of the appropriate IDE device type.
[CDROM] Select this option if you are specifically configuring a CD-ROM
drive.
[ARMD] Select [ARMD] (ATAPI Removable Media Device) if your device is
either a ZIP, LS-120, or MO drive.
LBA/Large Mode [Auto]
Enables or disables the LBA (Logical Block Addressing) mode.
[Auto] Select [Auto] to enable the LBA mode (Logical Block Addressing
mode) if the device supports this mode, and if the device was not
previously formatted with LBA mode disabled.
[Disabled] Disable this function.
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
Rampage III GENE BIOS SETUP Version 0213
Main
Select the type
of device connected
to the system.
←→ Select Screen
↑↓ Select Item
+- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
SATA 1
Device :Hard Disk
Vendor :HDT722516DLA380
Size :164.7GB
LBA Mode :Supported
Block Mode:16Sectors
PIO Mode :4
Async DMA :MultiWord DMA-2
Ultra DMA :Ultra DMA-5
SMART Monitoring:Supported
Type [Auto]
LBA/Large Mode [Auto]
Block(Multi-Sector Transfer)M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
SMART Monitoring [Auto]
32Bit Data Transfer [Enabled]