E14163_ZS600KL_Booklet_EU_UM.
First Edition/ June 2018 ASUS Phone (Mobile Phone) Model: ASUS_Z01QD (ZS600KL) Before you start, ensure that you have read all the safety information and operating instructions in this User Guide to prevent injury or damage to your device. NOTE: For the complete E-Manual and more detailed information, refer to https://www.asus.com/support/. Front features LED indicator Receiver & Speaker Front camera Proximity sensor and light sensor Touch screen display Speaker E14163_ZS600KL_Booklet_EU_UM.
Side & Rear features Microphone Microphone Rear cameras Camera flash Nano SIM card tray eject hole Fingerprint sensor Air Trigger touch sensor Nano SIM card slot NFC detection area Volume key Power key Side Mount connector Air Trigger touch sensor Rear cover Aura light Air Trigger touch sensor Microphone USB Type-C port Audio jack NOTES: • The USB Type-C port supports USB 2.0 transfer rate. The Side Mount connector Type-C port supports USB 3.1 Gen1 transfer rate.
Fan USB Type-C port Aura light Audio jack NOTE: Connect your AeroActive Cooler to the Side Mount connector of your ROG Phone. To install AeroActive Cooler: 1. Place your smartphone in a horizontal position. 2. Place the AeroActive Cooler on the back side of your phone with the ROG logo facing outwards. 3. Insert the USB plug of the AeroActive Cooler into the Side Mount connector of your Phone. 4. Push the top part of the AeroActive Cooler and snap the clip on the top side.
2 3 1 or USB Type-C port 2 3 * D O NOT insert a USB Type-C cable to this port. 1 or 2 3 1 NOTES: • We recommend that you charge your ROG phone through one USB Type-C port at a time. • Only the Side Mount connector has Display Port functionality. • If you connect USB Type-C OTG or charging devices to both of the USB Type-C ports on your ROG phone, the Side Mount connector will become the master and the charging current or OTG device on the bottom port will be limited.
Installing a Nano SIM card To install a Nano SIM card: 1. Push a pin into the hole on the Nano SIM card tray to eject it. Insert the Nano SIM card(s) into the card slot(s). n Na IM o-S n Na 1 IM o-S 2 2. Push the tray to close it. NOTES: • Both Nano SIM card slots support GSM/GPRS/ EDGE, WCDMA/HSPA+/DC-HSPA+, FDD-LTE, and TD-LTE DSDV network bands. Both Nano SIM cards can connect to VoLTE 4G calling service. But only one can connect to FDD-LTE, and TD-LTE data service at a time.
Federal Communications Commission Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.
absorbs RF energy. SAR limits are 1.6 Watts per kilogram (over a volume containing a mass of 1 gram of tissue) in countries that follow the United States FCC limit and 2.0 W/kg (averaged over 10 grams of tissue) in countries that follow the Council of the European Union limit. Tests for SAR are conducted using standard operating positions with the device transmitting at its highest certified power level in all tested frequency bands.
phone box. A phone is considered Hearing Aid Compatible for acoustic coupling (microphone mode) if it has an “M3” or “M4” rating. A digital wireless phone is considered Hearing Aid Compatible for inductive coupling (telecoil mode) if it has a “T3” or “T4” rating. The tested M-Rating and T-Rating for this device (ASUS_Z01QD) are M4 and T3. You’ll want to try a number of wireless phones so that you can decide which works the best with your hearing aids.
Additional Canadian information on RF exposure also can be found at the following web address: http://www.ic.gc.ca/eic/site/ smt-gst.nsf/eng/sf08792.html. This equipment should be installed and operated with minimum distance 15 mm between the radiator and your body. Cet appareil doit être installé et utilisé avec une distance minimale de 15 mm entre l’ émetteur et votre corps.
EU Radio Equipment Directive Compliance Simplified EU Declaration of Conformity Hereby, ASUSTek Computer Inc. declares that the radio equipment ASUS_Z01QD is in compliance with Directive 2014/53/EU. Full text of EU declaration of conformity is available at https://www.asus. com/support/. (Search for ZS600KL) RF Output Table Items Maximum Radio-Frequency Output Power Table Bluetooth WLAN 2.4GHz Bluetooth BR/EDR (2402~2480 MHz) 9.17(dBm) Bluetooth-LE 4.0 (2402~2480 MHz) 2.17(dBm) 802.
The Wi-Fi operating in the band 5150-5350MHz shall be restricted to indoor use for countries listed in the table below: AT BE BG CZ DK EE FR DE IS IE IT EL ES CY LV LI LT LU HU MT NL NO PL PT RO SI SK TR FI SE CH UK HR RF Exposure Information This ASUS product has been tested and meets applicable European SAR limits. The SAR limit is 2.0 W/kg in countries that set the limit averaged over 10 grams of tissue.
Using GPS (Global Positioning System) on your ROG Phone To use the GPS positioning feature on your ROG Phone: • Ensure that your device is connected to the Internet before using Google Map or any GPS-enabled apps. • For first-time use of a GPS-enabled app on your device, ensure that you are outdoors to get the best positioning data. • When using a GPS-enabled app on your device inside a vehicle, the metallic component of the car window and other electronic devices might affect the GPS performance.
• • Do not remove and dispose of the battery in fire. It could explode and release harmful substances into the environment. Do not remove and dispose of the battery with your regular household waste. Take it to a hazardous material collection point. • Do not touch the battery terminals. • To avoid fire or burns, do not disassemble, bend, crush, or puncture the battery. NOTES: • Risk of explosion if battery is replaced by an incorrect type. • Dispose of used battery according to the instructions.
Regional notice for Singapore This ROG Phone complies with IMDA Standards. India E-waste (Management) Rules 2016 This product complies with the “India E-Waste (Management) Rules, 2016” and prohibits use of lead, mercury, hexavalent chromium, polybrominated biphenyls (PBBs) and polybrominated diphenyl ethers (PBDEs) in concentrations exceeding 0.1% by weight in homogenous materials and 0.01 % by weight in homogenous materials for cadmium, except for the exemptions listed in Schedule II of the Rule.
DO NOT throw this product in municipal waste. This product has been designed to enable proper reuse of parts and recycling. The symbol of the crossed out wheeled bin indicates that the product (electrical, electronic equipment and mercury-containing button cell battery) should not be placed in municipal waste. Check local regulations for disposal of electronic products. DO NOT throw this product in fire. DO NOT short circuit the contacts. DO NOT disassemble this product.
ASUS Address: 4F, 150 Li-Te Rd., Peitou, Taipei, Taiwan Tel: 886228943447 Fax: 886228907698 Declaration We declare that the IMEI codes for this product, ROG Phone, are unique to each unit and only assigned to this model. The IMEI of each unit is factory set and cannot be altered by the user and that it complies with the relevant IMEI integrity related requirements expressed in the GSM standards. Should you have any questions or comments regarding this matter, please contact us.
15060-0LV00000 E14163_ZS600KL_Booklet_EU_UM.