User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.6 Advanced menu
- 3.6.1 Platform Misc Configuration
- 3.6.2 CPU Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 PCH Configuration
- 3.6.5 PCH Storage Configuration
- 3.6.6 PCH-FW Configuration
- 3.6.7 Onboard Devices Configuration
- 3.6.8 APM Configuration
- 3.6.9 PCI Subsystem Configuration
- 3.6.10 USB Configuration
- 3.6.11 Network Stack Configuration
- 3.6.12 HDD/SSD SMART Information
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Appendix
1-14
Chapter 1: Product Introduction
Chapter 1
7. CPU, AIO, and chassis fan connectors (4-pin CPU_FAN; 4-pin AIO_PUMP; 4-pin
CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
• DO NOT forget to connect the fan cables to the fan connectors. Insufcient air ow
inside the system may damage the motherboard components. These are not jumpers!
Do not place jumper caps on the fan connectors!
• Ensure that the CPU fan cable is securely installed to the CPU fan connector.
ROG STRIX B360-I GAMING Fan connectors
A
C
CHA_FAN
GND
CHA FAN PWR
CHA FAN IN
+5V
C
CPU_FAN
CPU FAN PWM
CPU FAN IN
CPU FAN PWR
GND
A
AIO_PUMP
+5V
CHA FAN IN
CHA FAN PWR
GND
B
B
• Connect the pump cable from the all-in-one cooler (AIO cooler) to the AIO_PUMP
header, and connect the fan cables to the CPU_FAN header.
• The CPU_FAN connector supports the CPU fan of maximum 1A (12 W) fan power.