Configuration Guide
Table Of Contents
- About this guide
- Intel® RAID Configuration
- 1. RAID definitions
- 2. Installing storage devices
- 3. Creating a SATA RAID set in UEFI BIOS
- 4. Creating an NVMe RAID set with onboard M.2 modules in UEFI BIOS
- 5. Creating an NVMe RAID set with expansion M.2 card in UEFI BIOS
- 6. Installing the RAID controller driver during Windows® 10 or Windows® 11 OS installation
1-6
Intel
®
RAID Configuration Guide
3. Creating a SATA RAID set in UEFI BIOS
You can create a RAID set with SATA mode M.2 modules and SATA SSD/HDD.
1. Enter the BIOS Setup during POST.
Refer to Chapter 3 in your motherboard’s user guide for details on entering and navigating
through the BIOS Setup.
2. Go to Advanced > System Agent (SA) Configuration > VMD Setup Menu.
3. In the VMD setup menu, set Enable VMD controller and Map SATA Controller
under VMD to [Enabled], and set Map PCIE Storage under VMD to [Disabled].
SATA RAID support varies between different motherboard models. Make sure to check
the product specification for more information.
4. Save your changes and exit the BIOS Setup, then enter the BIOS Setup again.
5. Go to Advanced > Intel(R) Rapid Storage Technology to display the Intel
®
Rapid
Storage Technology menu.