User Guide
Table Of Contents
- Notices
- Safety information
- Care & cleaning
- Takeback services
- 1.1 Welcome!
- 1.2 Package contents
- 1.3 Monitor introduction
- 2.1 Monitor standing positions
- 2.2 Connect the USB monitor with system
- 2.3 Assembling/Dis-assembling the ROG tripod
- 2.4 How to Adjust tilt strength of ROG Tripod
- 2.5 Announcements
- 3.1 OSD (On-Screen Display) menu
- 3.2 Specifications
- 3.3 Troubleshooting (FAQ)
- 3.4 Supported Timing List
2-4
Chapter 2: Setup
After adjusting the tilt strength by inbox Allen wrench, following below to
assemble ball shaft back
NOTE:
• ROG tripod supports tilt -5~90 degrees and swivel 360 degrees.
• ROG tripod can be the stand for products that implement standard
tripod hole.
• When the ball shaft is removed, it becomes a standard tripod, a
standard 1/4 thread is seen embedded.
• ROG tripod can only support product that is within 1.5kg, please don’t
connect with product that is over this weight.
CAUTION: ROG tripod doesn’t support Pivot function, please
don’t turn the monitor in clockwise or counterclockwise when
connecting with ROG tripod in case of any damage.