User Guide
Table Of Contents
- Notices
- Safety information
- Care & Cleaning
- Takeback Services
- 1.1 Welcome!
- 1.2 Package Contents
- 1.3 Assembling the Monitor Arm/Base
- 1.4 Connect Cables
- 1.5 Monitor Introduction
- 2.1 Detaching the Stand (for VESA Wall Mount)
- 2.2 Adjusting the Monitor
- 3.1 OSD (On-Screen Display) Menu
- 3.2 Aura
- 3.3 Specifications
- 3.4 Troubleshooting (FAQ)
- 3.5 Supported Timing List
2-1
Chapter 2: Setup
2.1 Detaching the Stand
(for VESA Wall Mount)
• Avoid damaging the monitor surface. While detaching the monitor stand, always
keep the monitor inside its EPS packaging.
The detachable stand of this monitor is specially designed for VESA wall
mount.
1. Disconnect power and signal cables. Carefully put the monitor facedown
on its EPS packaging.
2. Remove the covers on where the monitor and the arm meet.
3. Remove the four (4) screws securing the arm to the rear of the monitor.
4. Detach the stand (arm and base) from the monitor.