User Guide
Table Of Contents
- Contents
- Notices
- Safety information
- Care & Cleaning
- Takeback Services
- Product information for EU energy label
- Chapter 1: Product introduction
- 1.1 Welcome!
- 1.2 Package contents
- 1.3 Monitor introduction
- Chapter 2: Setup
- 2.1 Attaching the arm/base
- 2.2 Cable management
- 2.3 Detaching the arm/base (for VESA wall mount)
- 2.4 Adjusting the monitor
- 2.5 Connecting the cables
- 2.6 Turning on/off the monitor
- Chapter 3: General instructions
- 3.1 OSD (On-Screen Display) menu
- 3.2 Aura
- 3.3 Specifications summary
- 3.4 Outline dimensions
- 3.5 Troubleshooting (FAQ)
- 3.6 Supported operating modes
2-1ASUS PG32UQX Series LCD Monitor
2.1 Attaching the arm/base
To assemble the monitor base:
1. Insert the base into the arm (Figure 1).
2. Fix the base to the arm by fastening the bundled screw. (Figure 2).
3. Remove the rubber cap at the bottom of the base. (Figure 2).
4. Attach the LED projection cover to the stand. (Figure 3).
1
2
3
(Figure 1)
(Figure 2)
(Figure 3)
To change the lm on the LED projection cover, follow the illustration below.
1
2