User Manual
➋
Electronic File
inner rail
middle rail
outer rail
Click!
Click!
➊ Pull tab forward and take out inner rail.
➋ Push (a) and slide middle rail back.
➎ Please repeat installation steps for the other side.
⑤Please repeat the detached steps for the other side.
Copyright © 2021 King Slide. All Rights Reserved
White
(a)
➊ Key Hole .①-④
➋ Screw Hole.
Pull
②
lide inner rail
forward to remove inner rail.
Pull the latch upward and
remove the keyhole from
standoff and s
Click
Front bracket
Rear bracket Front bracket
➊
➍
Click
➌
➋
Push
①Loosen screw.
→Click Pull.
Ⓗ7.1 Round Hole
Ⓖ9.5 ( )Square Hole Pre-installed
ⒾM Bracket screw5-
Front Bracket
For 9.5 Square hole frame : Install slide rail as usual.
3) Check hole type on rack post. Choose
suitable pin of bracket to install if needed.
Rear Bracket
For 7.1 Round hole frame Please refer to the
manual Replacing the suitable pin.
:
:
ⒶM4x4L-P0.7
Ⓑ6-32X4L
Push
Push
Rear bracket
①
②
③
④
Please choose or
screw for inner rail
depends on chassis spec.
ⒶⒷ
Ⓖ
Ⓗ
Ⓘ
Ⓖ
Ⓗ
Ⓘ
Push
● iDetach nner rail from standoff● i
● brpDetach racket from ack ost● brp
SCREW SACK
ⒶM4x4L-P0.7
Inner rail
Ⓑ#6-32X4L
Inner rail
ⒸRound hole pin
ForØ7.1Round Hole
Ⓓ#10-32X13L
For#10-32 Thread Hole
ⒺM5X20-P0.8
For Shipping
ⒻM5x13.5L-P0.8
For Shipping
①
②
①
②
③
④
Install the inner rail onto the chassisInstall the inner rail onto the chassis
3
Fix the outer rail/bracket assembly to the frame
4
Remove the inner rail
Check hole type on rack post
1 2
R