User Manual
● Install in #10-32 rack●
①②
③④
Loosen shipping screws to pull out chassis.
Pull the disconnect tab forward to remove chassis at the full extension position.
White
➊
Ⓕ
Ⓓ
Ⓓ
➋
➌
①
②
③
Please follow previous steps for
installation and detach process of
chassis.
Copyright © 2021 King Slide. All Rights Reserved
➊
➋➌➍
Remove pins for square and round hole rack. Remove nut on the bracket.
Use #10-32 screw in the accessory bag, then fasten nut on the rack post.
Ⓖ
Ⓗ
Ⓘ
Ⓖ
Ⓗ
Ⓘ
Front Bracket
Rear Bracket
➍
● Remove the chassis from rack●
or
Thumb screw
(E)M5X20
➊➋
➌.
➍
➎
Pull the middle rails fully extended in lock position, ensure ball bearing retainer is located at the front of the middle rails.
When hit a stop, please pull/push the blue release tab on the inner rails.
Tighten chassis with shipping screws.
Horizontally insert the chassis into middle-outer rails
➊
➌
Blue
➍
Click
➋
➎
④
Insert the chassis to complete the installation
5
Electronic File
R