User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- 2.1 Chassis cover
- 2.2 Air ducts
- 2.3 Central Processing Unit (CPU)
- 2.4 System memory
- 2.5 Storage devices
- 2.6 Expansion slot
- 2.6.1 Installing an expansion card to the left PCIe riser card bracket
- 2.6.2 Installing an expansion card to the right PCIe riser card bracket
- 2.6.3 Installing a ASUS PIKE II card to the right PCIe riser card bracket
- 2.6.4 Installing an OCP 3.0 card to the OCP 3.0 slot
- 2.6.5 Installing an M.2 (NGFF) card
- 2.6.6 (optional) Installing the PFR module
- 2.6.7 Configuring an expansion card
- 2.7 Cable connections
- 2.8 Backplane cabling
- 2.9 Storage device configuration and cabling
- 2.10 Removable/optional components
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 Trusted Computing
- 5.5.2 PSP Firmware Versions
- 5.5.3 Redfish Host Interface Settings
- 5.5.4 APM Configuration
- 5.5.5 Onboard LAN Configuration
- 5.5.6 Serial Port Console Redirection
- 5.5.7 CPU Configuration
- 5.5.8 PCI Subsystem Settings
- 5.5.9 USB Configuration
- 5.5.10 Network Stack Configuration
- 5.5.11 CSM Configuration
- 5.5.12 NVMe Configuration
- 5.5.13 SATA Configuration
- 5.5.14 AMD Mem Configuration Status
- 5.6 Chipset menu
- 5.7 Security menu
- 5.8 Boot menu
- 5.9 Tool menu
- 5.10 Save & Exit menu
- 5.11 AMD CBS menu
- 5.12 Event Logs menu
- 5.13 Server Mgmt menu
- Chapter 6: Driver Installation
- Appendix
5-45
ASUS RS520A-E11-RS12U
The following item appears only when Trc Ctrl is set to [Manual].
Trc [39]
Specifies Active to Active/Refresh Delay Time. Valid values 87h-1Dh.
TrrdS [Auto]
Specifies the Activate to Activate Delay Time, different back group
(tRRD_S).
Configuration options: [Auto] [4 Clk] [5 Clk] [6 Clk] [7 Clk] [8 Clk] [9 Clk]
[0Ah Clk] [0Bh Clk] [0Ch Clk]
TrrdL [Auto]
Specifies the Activate to Activate Delay Time, same back group (tRRD_L).
Configuration options: [Auto] [4 Clk] [5 Clk] [6 Clk] [7 Clk] [8 Clk] [9 Clk]
[0Ah Clk] [0Bh Clk] [0Ch Clk]
Tfaw Ctrl [Auto]
Specifies Tfaw.
Configuration options: [Auto] [Manual]
The following item appears only when Tfaw Ctrl is set to [Manual].
Tfaw [1]
Specifies the Four Activate Window Time. Valid values 36h-6h.
TwtrS [Auto]
Specifies the Minimum Write to Read Time, different bank group.
Configuration options: [Auto] [2 Clk] [3 Clk] [4 Clk] [5 Clk] [6 Clk] [7 Clk] [8
Clk] [9 Clk] [0Ah Clk] [0Bh Clk] [0Ch Clk] [0Dh Clk] [0Eh Clk]
TwtrL [Auto]
Specifies the Minimum Write to Read Time, same bank group.
Configuration options: [Auto] [2 Clk] [3 Clk] [4 Clk] [5 Clk] [6 Clk] [7 Clk] [8
Clk] [9 Clk] [0Ah Clk] [0Bh Clk] [0Ch Clk] [0Dh Clk] [0Eh Clk]
Twr Ctrl [Auto]
Specifies Twr.
Configuration options: [Auto] [Manual]
The following item appears only when Twr Ctrl is set to [Manual].
Twr [12]
Specifies the Minimum Write Recovery Time. Valid values 51h-Ah.
Trcpage Ctrl [Auto]
Specifies Trcpage.
Configuration options: [Auto] [Manual]
The following item appears only when Trcpage Ctrl is set to [Manual].
Trcpage [0]
SDRAM Optional Features (tMAW MAC). Valid values 3FFh-0h.