User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 OffBoard SATA Controller Configuration
- 5.5.2 Trusted Computing
- 5.5.3 ACPI Settings
- 5.5.4 Redfish Host Interface Settings
- 5.5.5 Onboard LAN Configuration
- 5.5.6 Serial Port Console Redirection
- 5.5.7 SIO Common Setting
- 5.5.8 SIO Configuration
- 5.5.9 PCI Subsystem Settings
- 5.5.10 USB Configuration
- 5.5.11 Network Stack Configuration
- 5.5.12 CSM (Compatibility Support Module)
- 5.5.13 NVMe Configuration
- 5.5.14 APM Configuration
- 5.5.15 Intel(R) Virtual RAID on CPU
- 5.5.16 Third-party UEFI driver configurations
- 5.6 Platform Configuration menu
- 5.7 Socket Configuration menu
- 5.8 Event Logs menu
- 5.9 Server Mgmt menu
- 5.10 Security menu
- 5.11 Boot menu
- 5.12 Tool menu
- 5.13 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- Appendix
Chapter 2: Hardware Information
2-6
5. Align the CPU and heatsink assembly in the correct orientation so that the triangle
marks on both the CPU and socket are aligned in the same direction, then place the
heatsinks on top of the CPU sockets.
The CPU and CPU Carrier fits in only one correct orientation. DO NOT force the CPU and
CPU Carrier into the socket to prevent damaging the CPU pins on the socket.
The heatsink for RS720Q-E10-RS8U differs between CPU1 and CPU2, please refer to the
illustration below for more information on the heatsink and the corresponding CPU socket.
4. Attach the CPU to the carrier bracket, ensure the triangle mark is on the same side as
the bracket lever, then attach the CPU and carrier bracket to the heatsink.