User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 OffBoard SATA Controller Configuration
- 5.5.2 Trusted Computing
- 5.5.3 ACPI Settings
- 5.5.4 Redfish Host Interface Settings
- 5.5.5 Onboard LAN Configuration
- 5.5.6 Serial Port Console Redirection
- 5.5.7 SIO Common Setting
- 5.5.8 SIO Configuration
- 5.5.9 PCI Subsystem Settings
- 5.5.10 USB Configuration
- 5.5.11 Network Stack Configuration
- 5.5.12 CSM (Compatibility Support Module)
- 5.5.13 NVMe Configuration
- 5.5.14 APM Configuration
- 5.5.15 Intel(R) Virtual RAID on CPU
- 5.5.16 Third-party UEFI driver configurations
- 5.6 Platform Configuration menu
- 5.7 Socket Configuration menu
- 5.8 Event Logs menu
- 5.9 Server Mgmt menu
- 5.10 Security menu
- 5.11 Boot menu
- 5.12 Tool menu
- 5.13 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- Appendix
2-11
RS720Q-E10-RS8U
Ensure that the storage devices installed correspond to the correct node. For more
information on the nodes and the storage bays, please refer to 1.4 Front panel features
and 1.5 Rear panel features.
2.5 Storage devices
The system supports two (2) hot-swap storage devices per node. The storage device installed
on the drive tray connects to the Midplane via the backplane.
1. Press the spring lock to release the tray lever and to partially eject the tray from the
bay.
2. Firmly hold the tray lever and carefully pull the drive tray out of the bay.
2.5.1 Installing a 2.5” hot-swap SATA/SAS/NVMe storage
device