User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 OffBoard SATA Controller Configuration
- 5.5.2 Trusted Computing
- 5.5.3 ACPI Settings
- 5.5.4 Redfish Host Interface Settings
- 5.5.5 Onboard LAN Configuration
- 5.5.6 Serial Port Console Redirection
- 5.5.7 SIO Common Setting
- 5.5.8 SIO Configuration
- 5.5.9 PCI Subsystem Settings
- 5.5.10 USB Configuration
- 5.5.11 Network Stack Configuration
- 5.5.12 CSM (Compatibility Support Module)
- 5.5.13 NVMe Configuration
- 5.5.14 APM Configuration
- 5.5.15 Intel(R) Virtual RAID on CPU
- 5.5.16 Third-party UEFI driver configurations
- 5.6 Platform Configuration menu
- 5.7 Socket Configuration menu
- 5.8 Event Logs menu
- 5.9 Server Mgmt menu
- 5.10 Security menu
- 5.11 Boot menu
- 5.12 Tool menu
- 5.13 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- Appendix
2-17
RS720Q-E10-RS8U
2.6.2 Installing OCP 3.0 card
The illustrations in this section are for reference only. The OCP 3.0 card may differ
depending on the OCP 3.0 you purchased.
The OCP 3.0 slot does not support hot-plug, if you wish to install or remove the OCP 3.0
card, ensure to power off the system before installing or removing the OCP 3.0 card.
1. Remove the screw on the metal bracket, then remove the metal bracket.
2. Prepare OCP 3.0 card.
3. Align the OCP 3.0 card to the rails on the OCP 3.0 slot, then slide the OCP 3.0 card all
the way into the OCP 3.0 slot.