User Manual

5-17
RS720Q-E10-RS8U
Redirection After POST [Always Enable]
The default setting for this option is set to
[Always Enable]
.
[Bootloader] The legacy Console Redirection is disabled before booting to
legacy OS.
[Always Enable] Legacy Console Redirection is enabled for legacy OS.
Serial Port for Out-of-Band Management/
Windows Emergency Management Services (EMS)
Console Redirection EMS [Enabled]
Allows you to enable or disable the console redirection feature.
Conguration options: [Disabled] [Enabled]
The following item appears only when
Console Redirection EMS
is set to
[Enabled]
.
Console Redirection Settings
Out-of-Band Mgmt Port [COM1]
Microsoft Windows Emergency Management Services (EMS) allow for remote
management of a Windows Server OS through a serial port.
Conguration options: [COM1] [COM2]
Terminal Type EMS [VT-UTF8]
VT-UTF8 is the preferred terminal type for out0of-band management. The next best
choice is VT100+, and then VT100. See above, in Console Redirection Settings page
for more help with Terminal Type/Emulation.
Conguration options: [VT100] [VT100+] [VT-UTF8] [ANSI]
Bits per second EMS [115200]
Selects serial port transmission speed. The speed must be matched on the other side.
Long or noisy lines may require lower speeds.
Conguration options: [9600] [19200] [57600] [115200]
Flow Control EMS [None]
Flow control can prevent data loss from buffer overow. When sending data, if the
receiving buffers are full, a “stop” signal can be sent to stop the data ow. Once the
buffers are empty, a “start” signal can be sent to re-start the ow. Hardware ow control
uses two wires to send start/stop signals.
Conguration options: [None] [Hardware RTS/CTS] [Software Xon/Xoff]
Lock Legacy Resources [Disabled]
Allows you to enable or disable locking of Legacy Resources.
Conguration options: [Disabled] [Enabled]
5.5.7 SIO Common Setting