User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 OffBoard SATA Controller Configuration
- 5.5.2 Trusted Computing
- 5.5.3 ACPI Settings
- 5.5.4 Redfish Host Interface Settings
- 5.5.5 Onboard LAN Configuration
- 5.5.6 Serial Port Console Redirection
- 5.5.7 SIO Common Setting
- 5.5.8 SIO Configuration
- 5.5.9 PCI Subsystem Settings
- 5.5.10 USB Configuration
- 5.5.11 Network Stack Configuration
- 5.5.12 CSM (Compatibility Support Module)
- 5.5.13 NVMe Configuration
- 5.5.14 APM Configuration
- 5.5.15 Intel(R) Virtual RAID on CPU
- 5.5.16 Third-party UEFI driver configurations
- 5.6 Platform Configuration menu
- 5.7 Socket Configuration menu
- 5.8 Event Logs menu
- 5.9 Server Mgmt menu
- 5.10 Security menu
- 5.11 Boot menu
- 5.12 Tool menu
- 5.13 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- Appendix
5-27
RS720Q-E10-RS8U
The following item appears only when
SATA Controller
is set to
[Enable]
.
Configure SATA as [AHCI]
Allows you to identify the SATA port connected to Solid State Drive or Hard Disk Drive.
Conguration options: [AHCI] [RAID]
SATA Mode options
SATA HDD Unlock [Enable]
When this item is set to
[Enable]
the HDD password unlock will be enabled
in the OS.
Conguration options: [Disable] [Enable]
SATA Led locate [Enable]
If this item is enabled, LED/SGPIO is attached.
Conguration options: [Disable] [Enable]
Support Aggressive Link Power Management [Enable]
Allows you to enable or disable SALP.
Conguration options: [Disable] [Enable]
SATA Port 0-7
Hot Plug [Disable]
Allows you to designate SATA port 0-7 as hot pluggable.
Conguration options: [Disable] [Enable]
PCH sSATA Configuration
sSATA Controller [Enable]
Allows you to enable or disable the sSATA Controller.
Conguration options: [Disable] [Enable]
The following item appears only when
sSATA Controller
is set to
[Enable]
.
Configure sSATA as [AHCI]
Allows you to identify the SATA port connected to Solid State Drive or Hard Disk Drive.
Conguration options: [AHCI] [RAID]
sSATA Port 0-5
Hot Plug [Disable]
Allows you to designate sSATA port 0-5 as hot pluggable.
Conguration options: [Disable] [Enable]