User's Manual
Table Of Contents
- 1 Getting to know your wireless router
- 2 Getting started
- 3 Configuring the General and Advanced Settings
- 4 Utilities
- 5 Troubleshooting
- Appendices
95
3.19.2 WPS
WPS (WiFi Protected Setup) is a wireless security standard that
allows you to easily connect devices to a wireless network. You
can congure the WPS function via the PIN code or WPS button.
NOTE: Ensure that the devices support WPS.
To enable WPS on your wireless network:
1. From the navigation panel, go to Advanced Settings >
Wireless > WPS.
2. In the Enable WPS eld, move the slider to ON.
3. WPS uses 2.4GHz by default. If you want to change the
frequency to 5GHz, turn OFF the WPS function, click Switch
Frequency in the Current Frequency eld, and turn WPS ON
again.
NOTE: WPS supports authentication using Open System, WPA/
WPA2/WPA3-Personal. WPS does not support a wireless network that
uses a Shared Key, WPA-Enterprise, WPA2-Enterprise, and RADIUS
encryption method.