User Manual

4-28
Chapter 4: BIOS Setup
4.4.13 Network Stack Configuration
Allowsyoutocongurethenetworkstackconguration.
Network Stack [Enabled]
AllowsyoutoenableordisableUEFINetworkStack.
Congurationoptions:[Disabled][Enabled]
The following items appear only when
Network Stack
is set to
[Enabled]
.
Ipv4 PXE Support [Disabled]
EnablesordisablestheIpv4PXEBootSupport.Ifdisabled,Ipv4PXEbootoptionwill
not be created.
Congurationoptions:[Disabled][Enabled]
Ipv4 HTTP Support [Disabled]
EnablesordisablestheIpv4HTTPBootSupport.Ifdisabled,Ipv4PXEbootoptionwill
not be created.
Congurationoptions:[Disabled][Enabled]
Ipv6 PXE Support [Disabled]
EnablesordisablestheIpv6PXEBootSupport.Ifdisabled,Ipv6PXEbootoptionwill
not be created.
Congurationoptions:[Disabled][Enabled]
Device power-up delay [Auto]
Allowsyoutosetthemaximumtimethedevicetakesbeforethedevicereportsitselftothe
host controller properly.
[Auto]
usesdefaultvalue;foraRootportitis100ms,foraHubport
thedelayistakenfromHubdescriptor.
Congurationoptions:[Auto][Manual]
The following item appears only when
Device power-up delay
is set to
[Manual]
.
Device power-up delay in seconds [5]
Allows you to set the device power-up delay in seconds.
Usethe<+>or<->toadjust
the value. The values range from 1 to 40.
Mass Storage Devices
Allows you to select the mass storage device emulation type for devices connected.
Congurationoptions:[Auto][Floppy][ForcedFDD][HardDisk][CD-ROM]