User Manual

4-30
Chapter 4: BIOS Setup
Boot from Network Devices [Ignore]
Allows you to select the type of onboard LAN controller and installed LAN cards.
Networkdeviceswillruntheselectedtypeduringthesystemboot.Selecting
[Ignore]
willacceleratethebootuptimewithoutrunningnetworkdevicesduringPOST(Power-On
Self-Test).
Congurationoptions:[Ignore][UEFIonly][Legacyonly]
Boot from Storage Devices [UEFI only]
Allowsyoutoselectthetypeofstoragedevicestorunrstduringthesystemboot.It
is recommended to select either
[Legacy only]
or
[UEFI only]
according to devices
specicationforbetterstability.Selecting
[Ignore]
will accelerate the boot up time
withoutrunningnetworkdevicesduringPOST(Power-OnSelf-Test).
Congurationoptions:[Ignore][UEFIonly][Legacyonly]
Launch Video OPROM policy [UEFI only]
This option controls the execution of UEFI and Legacy Video OPROM.
Congurationoptions:[Ignore][UEFIonly][Legacyonly]
Boot from PCI-E/PCI Expansion Devices [UEFI only]
AllowsyoutoselectthetypeofPCI-E/PCIExpansiondevicestorunrstduringthe
system boot.
Congurationoptions:[Ignore][UEFIonly][Legacyonly]
4.4.15 NVMe Configuration
You may view the NVMe controller and Drive information if an NVMe device is connected.
4.4.16 APM Configuration
ThispagewillallowyoutoconguretheAdvancePowerManagement(APM)settings.
Restore AC Power Loss [Last State]
When set to
[Power Off]
,thesystemgoesintooffstateafteranACpowerloss.Whenset
to
[Power On]
,thesystemwillrebootafteranACpowerloss.Whensetto
[Last State]
,the
systemgoesintoeitherofforonstate,whateverthesystemstatewasbeforetheACpower
loss.
Congurationoptions:[PowerOff][PowerOn][LastState]