User Manual

Chapter 2: Hardware setup
2-18
6. Pushthetrayleveruntilitclicks,and
secures the drive tray in place. The drive
tray is correctly placed when its front
edgealignswiththebayedge.
7. Repeatsteps1to6ifyouwishtoinstall
asecondSATA/SASdrive.
2.5.5 Installing a 2.5-inch hard disk drive (TS700-E8-RS8
only)
Thesystemcomeswithtwohot-swap2.5-inchharddiskdrivesontherearpanelformounting
SATA/SASorSSDharddiskdrives.
Toinstalla2.5-inchharddiskdrive:
1. Releaseadrivetraybypushingthe
spring lock to the right, and then
pulling the tray lever outward. The
drive tray ejects slightly after you pull
out the lever.
Support
beam
3. Placethedrivetrayonaatsurface.
4. Release the screws on each side of
the drive tray to release the drive tray
metalbeam.
5. Findtheharddiskdriveyouwantto
installanditsbundledscrews.
Whenthedrivetrayisout,itscaseisfacingdownwards.
2. Firmlyholdthetrayleverandpullthe
drivetrayoutofthebay.