User Manual

Chapter 2: Hardware Setup
2-14
2. Firmly hold the tray lever and pull the
drivetrayoutofthebay.
3. Takenoteofthedrivetrayholes.
Eachsidehasthreeholestot
differenttypesofharddiskdrives.
Use two screws on each side to
securetheharddiskdrive.
4. PlaceaSATA/SASharddiskdrive
on the tray, and then secure it with
four screws.
2.5.4 Installing a hot-swap SATA/SAS hard disk drive
1. Releaseadrivetraybypushingthe
springlocktotheright,andthenpulling
the tray lever outward. The drive tray
ejects slightly after you pull out the lever.