User Guide

ASUS TUSL2-C User’s Manual 21
3. HARDWARE SETUP
Motherboard Settings
3. H/W SETUP
5) Voltage I/O Setting (VIO)
This jumper sets the voltage supplied to the DRAM, chipset, AGP, and PCI. The
default setting of 3.40V should be used unless processor overclocking requires a
higher voltage.
Setting VIO
3.30 V [1-2]
3.40 V [2-3] (default)
3.60 V [3-4]
TUSL2-C
®
TUSL2-C VIO Setting
VIO
3.30 V 3.40 V
12
2
3
3.60 V
3
4
(Default)
WARNING! Using a higher voltage may help when overclocking but may result
in the shortening of your computer component’s life. It is highly recommended
that you leave this setting on its default.
TUSL2-C
®
COM1
TUSL2-C Bass Center Setting
BCS1
BCS2
type 1 Bass
12
type 2 Bass
23
(CENTER/BASS) (BASS/CENTER)
(Default)
6) Bass Center Setting (BCS1, BCS2)
(NOTE: Only available on PCB 1.04 & later versions)
Use these jumpers in conjunction with the C-Media PCI Audio Driver to adjust
output for 6 speaker audio. No audio standard exists for the three pick-up
surfaces on male audio jacks, therefore it may be necessary to switch jumpers
from the default position, type 1, to type 2, in order to reroute signals among the
internal leads to the Line-In, Line-Out, Mic female sockets. Make sure a test is
made using the C-Media Audio Driver software setup available on the Support
CD. These jumpers effectively swap the audio channelsfor bass and center.