User Guide

36 ASUS TUV4X User’s Manual

3. HARDWARE SETUP

Connectors

3. H/W SETUP

4) Wake-On-LAN Connector (3-pin WOL_CON)

This connector connects to a LAN card with a Wake-On-LAN output. The

connector powers up the system when a wake up packet or signal is received

through the LAN card.

IMPORTANT: This feature requires that the Wake-On-LAN or PCI Device

parameter is enabled (see 4.5.1 Power Up Control) and that the system has an

ATX power supply with at least 720mA +5V standby power.

5) Wake-On-Ring Connector (2-pin WOR)

This connector connects to internal modem cards with a Wake-On-Ring output.

The connector powers up the system when a ringup packet or signal is received

through the internal modem card. NOTE: For external modems, Wake-On-Ring

is detected through the COM port.

IMPORTANT: This feature requires that the Power Up On External Modem

Act parameter is enabled (see 4.5.1 Power Up Control) and that the system has

an ATX power supply with at least 720mA +5V standby power.

TUV4X

TUV4X Wake-On-LAN Connector

IMPORTANT: Requires an ATX power

supply with at least 720mA +5 volt

standby power.

+5 Volt StandbyPME

Ground

WOL_CON

TUV4X

TUV4X Wake-On-Ring Connector

WOR

RI#

Ground