User Manual

71
Using the Notebook PC 4
Fingerprint Login
The ngerprint scanner can be used to replace the system bootup and/or Windows login password check.
To use this feature:
1. You must set a Supervisor Password on the “Security” page in BIOS SETUP UTILITY.
2. Password Check on the “Security” page in BIOS SETUP UTILITY must be set to [Fingerprint].
3� Choose Power-on Security in the “Control Center”�
4� Select “Replace the power-on and hard...”�
5� Select “Allow power-on security single
sign-on” in System Settings from the “Control
Center”� This page allows you to select
ngerprint logon options.
7. During system boot, you will see “Swipe nger to authorize access...”. If you do not successfully
do so in the allowed time, it will revert to “Enter Password: _”. Pressing the [ESC] key will show
“Biometric operation cancelled” and allow you to enter a password instead of using a ngerprint. In
either case, you will see ***ACCESS GRANTED*** when authorized.
8. If you used a ngerprint on system boot, you will also automatically login to Windows with your
account. You will see “Succeeded” on the login screen. If you used a password on system boot, you
will be required to use your ngerprint or type in a password to login to Windows.
6� Set the password type for power-on security
associated with your ngerprint in “Enroll or Edit
Fingerprints” from the “Control Center”� You will
be asked for the relevant BIOS password based
on your selection�