Installation guide

G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 18 G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 19
16. Unscrew both PCBs.
Unscrew all 5 screws from both PCB’s.
Note: Set aside screws for later re-assembly.
17. Remove the metal cover strip.
Remove the metal cover strip for the power connector.
Note: The removed metal cover strip will not be needed
during reassembly.
If discarding, do so in accordance with local laws.
18. Remove the PCBs.
Pull out and set aside both PCBs as shown.
Note: The boards can only be lifted on one side. The other
side is held in place by metal guides.