Installation guide

G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 22 G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 23
22. Insert the NVIDIA G-SYNC monitor module into the chassis.
Slide the board underneath the metal guides as shown. Position the board to
align the tooling holes with the chassis.
23. Attach display input connector metal plate cover.
First align the metal plate to cover the opening. Next use one of the small
screws to fasten the DP connector.
24. Attach power connector metal plate cover.
Align the metal plate cover with the power connector and attach
it to the chassis.
Note: You may need to secure the replacement metal plate
cover with electrical tape.
25. Align all of the PCB screws and tighten.
Align the holes with a small screwdriver as needed and insert the 5 mounting
screws. Do not tighten fully. Once all screws fit, hand-tighten all screws. Do
not over tighten. Insert and tighten the screw, set aside from earlier, above the
DisplayPort connector.