Installation guide

G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 24 G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 25
26. Re-attach the insulation to the chassis.
Re-insert the black insulation to the chassis inserting all four flaps into the four
slots on the chassis.
27. Place the chassis back onto the LCD panel.
Before installing the assembled chassis back on the panel, ensure there is no
material within the area you marked earlier. Align the assembled chassis with
the markings you made earlier at the four corners.
28. Reconnect the LVDS and power cables.
Connect the cables from the chassis to the LVDS and power connectors. Ensure
that the two LVDS cables are not twisted. They should run parallel to each other
from the module to the LCD panel and the metal plate on the connector should
be face up and visible.
29. Tape down the cables.
Use the black tape to hold down LVDS cables as shown.