Installation guide

G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 26 G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 27
30. Reconnect the backlight cable.
Insert the backlight power connector into the left power input connector
(labeled J1).
31. Reconnect the blue flex cable.
Insert the front panel blue flex cable into the connector marked J6 as shown.
Push it in completely until locked.
Note: You may need to detach the tape holding the blue flex
cable to the chassis to enable the cable to fully reach the
connector.
If you have difficulty raising the top of the connector, do not
apply excessive force.
Insert the pointed tip of the plastic shim tool into the guide
holes on the top of the connector to unlock and separate the
top from the connector body (as shown in the picture). Once
separated, raise the top of the connector.
After the cable is inserted, push the connector top down and
back to lock it in place.
Guide
holes